View Single Post
Old 01-03-2008, 12:35   #11
Texas_XD
Senior Member
 
Texas_XD's Avatar
 
Join Date: Aug 2006
Location: De Leon, TX
Posts: 333
Quote:
Originally Posted by MAX100 View Post
It would be excellent for a Glock slide. You will need to tape off the the inside dovetail cuts because it will add dimensions. The rails on the side of the slide will be ok. Also tape any lettering with very thin non sticky tape and spray those areas lightly at the end. The lettering on the slide is so fine it is going to be hard to keep from filling it in. If you hold the can way back and dust it that will probably work. I would say practice on some scrap metal. You can put a scratch in the metal about as deep as the lettering on a Glock and see what happens.


GC

I had actually considered just filling in the lettering with crayon then after sparaying remove. Not sure it would work.. but I can try, this poor thing has more bare spots from holster wear then finish.
Texas_XD is offline   Reply With Quote