[malcarjeb]

I'm sure this has been asked before but I can't find it-- Can you use redding 10mm dies to load the 40sw? The dies in question is Redding part num. 88520

Thanks

[IndyGunFreak]

Originally Posted by malcarjeb

I'm sure this has been asked before but I can't find it-- Can you use redding 10mm dies to load the 40sw? The dies in question is Redding part num. 88520

Thanks

Most of the time, yes. Those for whatever reason, are specifically marked 10mm, then they also have a 10mm/40 set(88253)... This would lead me to believe that for some reason, your dies are 10mm only... That's just a guess though.

IGF

[shotgunred]

You have to readjust them. well the last two at least.

[G10mm]

Originally Posted by malcarjeb

I'm sure this has been asked before but I can't find it-- Can you use redding 10mm dies to load the 40sw? The dies in question is Redding part num. 88520

Thanks

If these are the dies I am thinking about they are size the hole case all the way down to the bottom of the case . If you shot Glock brass threw other guns this is the die you need . I would call redding up and ask them . After all
they made . Trying to navagate there web site sucks big time .

[Colorado4Wheel]

10mm sizing die will size .40 all the way down.

[malcarjeb]

Got the Dies to day and they say on them: 40sw/10mm so must be good for both. Thanks