Need some help/advice.
Full disclosure...I'm an idiot. It's my fault. I broke it. I'm stupid....
Ok...before I did ALL my research on my 642 I read that doing a lot of dry firing and cleaning can smooth out the trigger...not lighten but smooth.
Well I guess as hard as I tried to be gentle with my brush on my exposed 642 frame/internals, the pin/post that supports the hammer and fits into the cover piece broke off.
I'm assuming I have a useless piece of metal surrounded by spare parts for my next 642 that I will have a ton more respect for. Am I wrong? Can the post be repaired or will it be considered "comprimised"? This is my pocket gun so I would need reliability. I'm not afraid to buy a new one and treat it appropriately.
I'm not rich but a $400 lesson is not the end of the world...
Advice...? Besides not being a dumb sh ..... it in the future