[glock20c10mm]

Has anyone else at least thought about an aftermarket barrel in 357SIG for their Kahr 40S&W pistol?

I can't find any aftermarket barrel availability for that idea. Has anyone had an aftermarket barrel custom made for their Kahr 40?

Thoughts?

[ehornad]

Barsto was willing to do it, but we never got enough people together to make a run.

[czgunner]

Couldn't you buy a 9mm barrel and ream the chamber to 357SIG?

[glock20c10mm]

Originally Posted by czgunner

Couldn't you buy a 9mm barrel and ream the chamber to 357SIG?

I suppose, but I'm not set up for any reaming, or machining at all (ok, I have a dremmel tool ). So if I used a Kahr 9mm barrel, which I suspect isn't available aftermarket, it would probably have to be purchased from Kahr, and this is all assuming 9 & 40 Kahr barrels are the exact same profile (I don't know), and then sent out be be reamed aftermarket anyway, and by that time it could be that I might as well call Barstow anyway. And, I suppose I'ld call Barstow anyway for a complete custom job, as the platform will be a PM40 (3" barrel), and I want the barrel 1" longer than stock at 4", though, there are 4" barreled Kahrs, and I don't know if they are all designed alike where they lock up in the frame. Hmmmmm.


Craig

[czgunner]

I know that people have reamed 9mm barrels to 357SIG for other guns.
I don't think I would want a PM, but the K/P series would be nice!
Reamer
Read this thread

[glock20c10mm]

Originally Posted by czgunner

I know that people have reamed 9mm barrels to 357SIG for other guns.
I don't think I would want a PM, but the K/P series would be nice!
Reamer
Read this thread

Thanks for the links.