[BlayGlock]

Just picked this up in a trade from E5MC here on the board. I have to say I am impressed initially by Dave Helton's work. He does a good job. Here is a list of everything that was done to it:

Checker @ 25LPI
Kart Barrel & Bushing
Heinie rear sight
Berryhill ignition
Bullet Proof slide lock
Bullet Proof extractor
Bullet Proof ejector, drilled and pinned
Wilson thumb safety
Serrate rear of slide
Flat trigger
NightHawk 25LPI MSH/Magwell
Finished all Black





Even though it is cold (for Texas) I am going go try and put some rounds through it this afternoon.
<!-- / message --><!-- sig -->

[Quack]

Nice!!! Didn't he just get that back?

[BlayGlock]

Yes. The gun has never been fired, before or after the work!

[Hokie1911]

Me likey....except the QuackTrigger.

[knedrgr]

different hammer?

[Wade-19]

Dave does really nice work. He did a Pro Carry for me last year that turned out great !

[BlayGlock]

Just got back from shooting it. I only shot 100 rounnds but did not have any feeding problems. I did not like my Les Baer mags (would not lock back on last round) but my Wilson and Nighthawk mags worked fine. It is not as accurate as my Guncrafter No Name, but I could keep an entire magainze in the A zone of an IPSC target freehand at 25 yards. Good enough for me.

I am not sure about the "Quack" trigger yet either. I am going to shoot it a little more before changing it out.

MOAR GUN PRON!!!!!!!!!

[rsxr22]

Very nice BlayGlock!!!! I regret letting mine go, but this is almost exactly what I would have wanted to do to mine. Those Shredder's look pretty good on it as well!