I looked for one and couldn't finde one so I made one.
first pic is front-left, shows the sheet metal chute the brass slides down and into the bin, spent primers are cought in an old medicine bottle and is wired in place, a shop vac is used to suck out the old primers when it gets full
second pic is rear-right, shows the flat stock (primer gray) attached to the monting bolt of the press with the banding material ("Z" bent) used to push the brass out of the shell holder
third pic is right looking down, shows how it lines up.
with the flat stock/banding material configured this way I can adjust when the brass is pushed out of the shell holder so I'm able to use it with everything from 9mm to 30-06 brass.
the bends in the end of the banding material that contacts the brass was just tinkered with until it worked, been using this for over 20 "+" years.