And you don't want to try finishing an Ironwood stock? When you get them, they are ready for staining...I mean 100% ready. It's a lot easier than you think, even if you've never finished any wood...
Ironwood before
Ironwood after
__________________
Pittsburgh Steelers fan till the day I die, and then some.
Ironwood=$130 plus shipping+cost of hardware+time and $ to stain wood.
Timbersmith=$125 shipped, includes all hardware, already stained.
From what I am seeing on various internet webpages, I have to do alittle filing on the timbersmith due to the MAK 90 having a 1.5mm receiver. The only PITA part will be the hanguard. Will need to do some sanding on the inside to make it fit. Got my dremel ready.
FYI- finally did the full 922R compliance thing to my NHM90. The tapco/timbersmith brown laminate wood stock fit perfectly, no mods needed. Just a very slight gap that is hardly noticeable. The only pain in the butt was the lower handguard which required lots of sanding and some trimming. Also cut notch in safety lever to hold bolt open.
Linear Mode
